M-DRIVE Pro Sprayer Bottle 600ml VITON
This is a heavy duty pro sprayer bottle that can be used with most available hobby and household/garage chemicals and used when cleaning your RC model.
See below for our recommended super affordable mix rate with your own household/garage fluids that works equally good (or better) that bike cleaners etc.
Pro Sprayer Features and Specs:
- Heavy Duty construction
- Chemical resistant VITON seals
- Suitable for most hobby chemicals (PH1-9)
- High output sprayer pump action
- Adjustable nozzle
- Total volume: 630ml
- Graduated scale in ml (600ml)
- Graduated mix-scale in procent (2-10%)
- Size: 265 x 110 x 80mm
- Weight (without fluids): 98g
Pro Sprayer Suitable Fluids:
- Automotive alkaline degreasers
- Automotive car shampoos
- Water (use at home while spraying your flowers etc)
- Dishwashing fluid (mix a small amount with water for cleaning windows/mirrors)
- Disinfectant surface cleaning fluids (for gyms etc)
- It even works with denatured cleaning alcohol/ethanol! (The seals are not 100% optimized for that but our test have shown it works much better that most other sprayers on the market!)
- The expected lifespan of the pump can vary depending on how it's used and what chemicals that have been used
RC car and bike cleaning solution mix:
This is a super affordable ”DIY” cleaning mix that you easily can modify yourself by simple adding more or less cleaning fluids depending on how strong results you want. The cost of a full bottle of the cleaning fluids is only around 1-2 euros (depending on what brands of cleaning fluids you use).
- Fill the Pro Sprayer bottle with water up to the H2O grade (see the grades on the edge of the bottle - it’s approximately 570ml).
- Add 6% of normal concentrated automotive alkaline pre-cleaner fluid. This is the type of ”degreaser” that actually aren’t degreasing per say - but it cleans normal dirt and is normally used as a pre-cleaning fluid if you have a really dirty full scale car (spray it on, let sit for a while and then rinse off with water before shampooing it etc). Note, don’t confuse it with a automotive naphtha based degreaser fluid as that is much more aggressive and also degreases your bearings etc (don’t use that type for this application).
- Add 4% of a normal automotive car shampoo. It really doesn’t matter what you use for this application. If you don’t have any in your garage already, get a non expensive one.
- Mix done. The perfect cleaning solution for your RC car or MTB bike etc.
RC Car Cleaning Tips:
- Brush off loose dirt with a brush (paint brush of tooth brush)
- If you have a vehicle with ”waterproof” electronics - make sure the sealing o-rings in the servo(s) and receiver box are seated and looks ok.
- Use the cleaning fluid mix described here above and spray it on your dirty RC car. Let it sit for a few minutes - before it dries use a tooth brush or paint brush to agitate the dirt and then rinse it with water.
- Use a soft cloth/towel to dry it off and let it sit to completely dry.
- When dry, check that the suspension moves freely, check to see of there any screws or nuts that have come lose etc (tighten or replace them).
- Use a small amount of spray oil to lubricate the bearings (like WD40).
- Use suitable protective gloves and clothes when using chemicals such as these.
Υπάρχουσες Κριτικές: 0
