RDLohr's Micro Servo Centering Tool
NOTE: THIS IS FOR MICRO SIZE SERVOS ONLY. (Servos such as the Hitec HS-65MG, Hitec HS-5065MG, Futaba S3156, JR DS285, etc. 450 Class helicopters typically)
This one is for a micro size servo. You can use it on or off the heli, with or without linkages. Line up the horizontal slot with the horn holes then snug it down. Use sub-trim to line up the edge of the tool with the outside edge of the servo. It's similar to using a pitch gauge. Flip it over for servos with the horn on the other side.
NOTE: THIS IS FOR MICRO SIZE SERVOS ONLY. (Servos such as the Hitec HS-65MG, Hitec HS-5065MG, Futaba S3156, JR DS285, etc. 450 Class helicopters typically)
This one is for a micro size servo. You can use it on or off the heli, with or without linkages. Line up the horizontal slot with the horn holes then snug it down. Use sub-trim to line up the edge of the tool with the outside edge of the servo. It's similar to using a pitch gauge. Flip it over for servos with the horn on the other side.
Υπάρχουσες Κριτικές: 0
